|
What tool would be used to check for line voltage sags?
| ( | A | ) | | Surge protector |
 |
| ( | B | ) | | Feedback circuit |
|
| ( | C | ) | | Terminal adapter |
|
| ( | D | ) | | Polarity tester |
|
| ( | E | ) | | High frequency monitor |
The Correct Answer is: D
The most chosen answer was [ A ] :: [ Surge protector ]
Explanation:
A Polarity tester is useful whenever there is a need to check for the presence of low voltage in insulated conductors, without having to touch the live cable or wire.
Which of the following files is NOT required for DOS to boot?
(this question provided by simulationexams.com)
| ( | A | ) | | COMMAND.COM |
|
| ( | B | ) | | MSDOS.SYS |
|
| ( | C | ) | | IO.SYS |
|
| ( | D | ) | | AUTOEXEC.BAT |
|
| ( | E | ) | | None of the above are required |
The Correct Answer is: D
Explanation:
The
file load order to start DOS is :
IO.SYS
MSDOS.SYS
CONFIG.SYS
COMMAND.COM
AUTOEXEC.BAT
Note
that CONFIG.SYS, and AUTOEXEC.BAT are optional to load DOS where as IO.SYS,
MSDOS.SYS, COMMAND.COM are required.
Which of the following Modem commands would be used to disconnect (hang up)?
| ( | A | ) | | ATZ |
|
| ( | B | ) | | ATH |
|
| ( | C | ) | | ATDT |
|
| ( | D | ) | | AH0 |
|
| ( | E | ) | | EXIT |
The Correct Answer is: B
Explanation:
ATH can be typed into a terminal input screen to disconnect or hang up from a call.
A 3.5" High-Density floppy disk typically holds ___ of data.
| ( | A | ) | | 420KB |
|
| ( | B | ) | | 780KB |
|
| ( | C | ) | | 1.2MB |
|
| ( | D | ) | | 1.44MB |
|
| ( | E | ) | | 1.6MB |
The Correct Answer is: D
Explanation:
A high-density 3.5" floppy disk has a storage capacity of 1.44MB.
You are reported that the monitor at a client's place is having a problem. You are about to remove the cover of the monitor. What do you do just before opening the monitor cover? Choose all that apply.
(this question provided by simulationexams.com)
| ( | A | ) | | Wear wrist strap to prevent ESD damage to the monitor |
|
| ( | B | ) | | Make sure that the power is switched off and the power cord is plugged out |
|
| ( | C | ) | | Make sure that the ESD is grounded properly |
|
| ( | D | ) | | Connect the Monitor as well as the wrist strap to the ground. |
|
| ( | E | ) | | All of the above |
The Correct Answer is: B
Explanation:
Never wear a wrist strap when working on monitors.
Monitors contain very high voltages, sometimes fatal to human, even when the
power is turned off. If you are wearing wrist strap, the human body work as a
conduit to discharge the electric charge.
This quiz was generated by user ariaam in april2002.
a+ certification || gmat test prep || pool game || funny joke
|
