|
Which protocol is used by the Internet?
| ( | A | ) | | IPX/SPX |
 |
| ( | B | ) | | NetBIOS |
|
| ( | C | ) | | Data Link |
|
| ( | D | ) | | TCP/IP |
|
| ( | E | ) | | Microsoft Talk |
The Correct Answer is: D
The most chosen answer was [ D ] :: [ TCP/IP ]
Explanation:
The TCP/IP protocol is used to connect networks on the Internet.
Which of the following is the port address for serial port COM1?
(this question provided by simulationexams.com)
| ( | A | ) | | 3F0-3F7 |
|
| ( | B | ) | | 2F8-2FF |
|
| ( | C | ) | | 320-32F |
|
| ( | D | ) | | 3F8-3FF |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
Explanation:
You need to memorize the following port addresses
before attending the exam.
Port-Base
address (in hex)
COM4:
2E8-2EF
COM2:
2F8-2FF
COM3:
3E8-3EF
COM1:
3F8-3FF
LPT2 :
278-27F
LPT1 :
378-37F
Floppy Controller:
3F0-3F7
Hard Drive Controller, 16
bit, ISA: 1F0-1F8
While booting up, a client's computer shows an error message with a code 201. What is the likely cause?
(this question provided by simulationexams.com)
| ( | A | ) | | The CMOS battery is bad |
|
| ( | B | ) | | The CPU is bad |
|
| ( | C | ) | | The Hard disk is bad |
|
| ( | D | ) | | The Memory test has failed |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
Explanation:
The general errors and the corresponding failures
are shown below:
100-199 : System board failures
200-299 : Memory failures
300-399 : Key board failures
400-499 : Monochrome video problems
500-599 : Color video problems
600-699 : Floppy disk errors
1700-1799: Hard disk problems.
Which function key is pressed to bypass CONFIG.SYS, and AUTOEXEC.BAT during the DOS boot process?
(this question provided by simulationexams.com)
| ( | A | ) | | F6 |
|
| ( | B | ) | | F8 |
|
| ( | C | ) | | F4 |
|
| ( | D | ) | | F5 |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
Explanation:
To bypass the CONFIG.SYS, and AUTOEXEC.BAT files during boot process of DOS, you need to press F5. F8 allows you to selectively bypass commands in AUTOEXEC.BAT, and CONFIG.SYS.
Which of the following files is NOT required for DOS to boot?
(this question provided by simulationexams.com)
| ( | A | ) | | COMMAND.COM |
|
| ( | B | ) | | MSDOS.SYS |
|
| ( | C | ) | | IO.SYS |
|
| ( | D | ) | | AUTOEXEC.BAT |
|
| ( | E | ) | | None of the above are required |
The Correct Answer is: D
Explanation:
The
file load order to start DOS is :
IO.SYS
MSDOS.SYS
CONFIG.SYS
COMMAND.COM
AUTOEXEC.BAT
Note
that CONFIG.SYS, and AUTOEXEC.BAT are optional to load DOS where as IO.SYS,
MSDOS.SYS, COMMAND.COM are required.
This quiz was generated by user guest533430 in august2002.
a+ certification || gmat test prep || pool game || funny joke
|
