|
You have loaded Windows 3.1 into the primary partition on your computer, and made it the default Operating System. You have formatted one of the logical drives in the Extended partition. Which file system would have been installed?
(this question provided by simulationexams.com)
| ( | A | ) | | FAT16 |
 |
| ( | B | ) | | FAT32 |
|
| ( | C | ) | | VFAT |
|
| ( | D | ) | | NTFS |
|
| ( | E | ) | | None of the above |
The Correct Answer is: A
The most chosen answer was [ D ] :: [ NTFS ]
Explanation:
-
DOS natively supports only FAT16.
-
Since Windows 3.1 runs on top of DOS, it will also support only FAT16
file system.
-
FAT32 is supported by Windows 98 and Windows 95 OEM Release 2.
-
Note that Windows NT does not support FAT32. NT supports only FAT16 and
NTFS.
Windows 2000 supports FAT16, FAT32, and NTFS
COM 2 uses which of the following I/O addresses?
| ( | A | ) | | 2c6 |
|
| ( | B | ) | | 3a7 |
|
| ( | C | ) | | 3f8 |
|
| ( | D | ) | | 4e2 |
|
| ( | E | ) | | 2f8 |
The Correct Answer is: E
Explanation:
COM 2 is assigned the the I/O address 2f8.
IRQ2 is used with which of the following?
(this question provided by simulationexams.com)
| ( | A | ) | | COM1 |
|
| ( | B | ) | | COM2 |
|
| ( | C | ) | | LPT1 |
|
| ( | D | ) | | Used to cascade the second IRQ controller |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
Explanation:
The IRQ numbers and relevant Standard Device
Assignment are given below. It is important to memorize these values before
going to the exam, as there would be 5-10 questions on IRQs, and conflicts.
| IRQ |
Standard device Assignment |
| 0 |
System Time |
| 1 |
Keyboard |
| 2 |
Cascade to IRQ9. Can't be used |
| 3 |
COM ports 2 and 4 |
| 4 |
COM ports 1 and 3 |
| 5 |
Parallel Port LPT2. Often used for sound cards |
| 6 |
Floppy drive controller |
| 7 |
Parallel
Port, LPT1 |
| 8 |
Real Time Clock |
| 9 |
Unassigned (Also redirected from IRQ2 |
| 10 |
Available |
| 11 |
Available - Usually for SCSI adapter |
| 12 |
Mouse or touch pads |
| 13 |
Math co-processor |
| 14 |
Primary hard-disk IDE controller |
| 15 |
Secondary hard-disk controller |
The first physical sector in any bootable hard disk contains which of the following?
(this question provided by simulationexams.com)
| ( | A | ) | | File structure |
|
| ( | B | ) | | Data structure |
|
| ( | C | ) | | MBR |
|
| ( | D | ) | | LBR |
|
| ( | E | ) | | None of the above |
The Correct Answer is: C
Explanation:
The first physical
sector on any bootable hard disk contains Master Boot Record, MBR.
What is the connector type that goes with a CGA / EGA monitor?
(this question provided by simulationexams.com)
| ( | A | ) | | DB-25 |
|
| ( | B | ) | | DB-15 |
|
| ( | C | ) | | DB-9 |
|
| ( | D | ) | | DB-5 |
|
| ( | E | ) | | None of the above |
The Correct Answer is: C
Explanation:
If you are using a Monochrome / CGA/ EGA monitor, it is a digital monitor and will have a DB-9 Male connector that plugs into a digital adapter. If you are using a VGA/ SVGA monitor, it will have a male DB-15 connector that plugs into an analog adapter. You should never interchange an analog monitor to that of a digital adapter and vice versa, or severe damage may take place.
This quiz was generated by user buer in dec2002.
a+ certification || gmat test prep || pool game || funny joke
|
