|
How should the jumpers be set on an IDE CD-ROM drive that is attached to the primary IDE adapter with a hard drive?
| ( | A | ) | | All Jumpers |
 |
| ( | B | ) | | No Jumpers |
|
| ( | C | ) | | Master |
|
| ( | D | ) | | Cable select |
|
| ( | E | ) | | Slave |
The Correct Answer is: E
The most chosen answer was [ C ] :: [ Master ]
Explanation:
The IDE Hard drive should be set as the master and the CD-ROM drive as the slave.
Which of the following is not a part of a standard Laser Printer?
| ( | A | ) | | Paper guides |
|
| ( | B | ) | | Thermal fuse |
|
| ( | C | ) | | Ozone Filter |
|
| ( | D | ) | | Transfer Corona |
|
| ( | E | ) | | Iron heat fuser |
The Correct Answer is: E
Explanation:
Laser printers consist of all the choices given except for the Iron heat fuser, which doesn't exist.
Of the following DMA Channels, which is most commonly used by the Sound Card?
| ( | A | ) | | DMA0 |
|
| ( | B | ) | | DMA1 |
|
| ( | C | ) | | DMA2 |
|
| ( | D | ) | | DMA3 |
|
| ( | E | ) | | DMA4 |
The Correct Answer is: B
Explanation:
DMA1 is most commonly used for sound cards. This is the channel that has the most conflicts and should be checked first if conflicts arise. Typical conflicts with this channel arise with network cards, SCSI host adapters, and voice modems.
On an Ethernet 10BaseT network what is the maximum data speed that can be carried through a CAT 5 cable?
| ( | A | ) | | 100 megabits/second |
|
| ( | B | ) | | 80 megabits/second |
|
| ( | C | ) | | 20 megabits/second |
|
| ( | D | ) | | 16 megabits/second |
|
| ( | E | ) | | 4 megabits/second |
The Correct Answer is: A
Explanation:
CAT 5 cable can carry data at a maximum speed of 100 megabits/second.
CAT 4: 20 megabits/second
CAT 3: 16 megabits/second
CAT 2: 4 megabits/second
CAT 1 wire is used with standard telephone lines inside a home.
Which function key is pressed to bypass CONFIG.SYS, and AUTOEXEC.BAT during the DOS boot process?
(this question provided by simulationexams.com)
| ( | A | ) | | F6 |
|
| ( | B | ) | | F8 |
|
| ( | C | ) | | F4 |
|
| ( | D | ) | | F5 |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
Explanation:
To bypass the CONFIG.SYS, and AUTOEXEC.BAT files during boot process of DOS, you need to press F5. F8 allows you to selectively bypass commands in AUTOEXEC.BAT, and CONFIG.SYS.
This quiz was generated by user pdev55 in dec2002.
a+ certification || gmat test prep || pool game || funny joke
|
