|
There are many different connector types that are used on network cables. Which of the following is a common Network Cable Connector?
| ( | A | ) | | BNC |
 |
| ( | B | ) | | RJ-45 |
|
| ( | C | ) | | AUI |
|
| ( | D | ) | | ST / SC |
|
| ( | E | ) | | All of the above are connectors |
The Correct Answer is: E
The most chosen answer was [ D ] :: [ ST / SC ]
Explanation:
They are all common network cable connectors.
BNC: used with coaxial cables
RJ-45: used with 8-wire network cables, most commonly found with Ethernets.
AUI: used with coaxial cables
ST / SC: used with fiber optic cables
Capacitors are measured in...
| ( | A | ) | | Ohms |
|
| ( | B | ) | | Farads |
|
| ( | C | ) | | Volts |
|
| ( | D | ) | | Spindles |
|
| ( | E | ) | | Fusers |
The Correct Answer is: B
Explanation:
The Farad is the basic unit of measurement for Capacitors.
Using the Autoexec.bat file, how would you load device drivers into Upper Memory?
| ( | A | ) | | UpperMem= |
|
| ( | B | ) | | LoadHigh= |
|
| ( | C | ) | | EMM= |
|
| ( | D | ) | | HighLoad= |
|
| ( | E | ) | | Autoexec= |
The Correct Answer is: B
Explanation:
Starting a line with "LoadHigh=" followed by the location and name of the driver will load that device into Upper Memory the next time the Autoexec.bat file is run.
COM 1 uses which of the following I/O addresses?
| ( | A | ) | | 2c6 |
|
| ( | B | ) | | 3a7 |
|
| ( | C | ) | | 3f8 |
|
| ( | D | ) | | 4e2 |
|
| ( | E | ) | | 2f8 |
The Correct Answer is: C
Explanation:
COM 1 is assigned the the I/O address 3f8.
Which IRQ is assigned for floppy drives?
| ( | A | ) | | IRQ 4 |
|
| ( | B | ) | | IRQ 6 |
|
| ( | C | ) | | IRQ 12 |
|
| ( | D | ) | | DMA 1 |
|
| ( | E | ) | | IRQ 8.5 |
The Correct Answer is: B
Explanation:
IRQ 6 is reserved for the Floppy drive.
IRQ 4 is defaulted to COM1, COM3
IRQ 12 is empty and can be assigned any new device.
This quiz was generated by user guest257114 in feb2002.
a+ certification || gmat test prep || pool game || funny joke
|
