|
Capacitors are measured in...
| ( | A | ) | | Ohms |
 |
| ( | B | ) | | Farads |
|
| ( | C | ) | | Volts |
|
| ( | D | ) | | Spindles |
|
| ( | E | ) | | Fusers |
The Correct Answer is: B
The most chosen answer was [ C ] :: [ Volts ]
Explanation:
The Farad is the basic unit of measurement for Capacitors.
While installing an expansion board into a PC you are faced with a device conflict error. From the choices below, which is NOT likely to be related to the conflict.
| ( | A | ) | | DMA Channels |
|
| ( | B | ) | | RAM Addresses |
|
| ( | C | ) | | I/O Addresses |
|
| ( | D | ) | | ROM Addresses |
|
| ( | E | ) | | None are related to the conflict |
The Correct Answer is: B
Explanation:
RAM Addressing is not likely to be the cause of the conflict. You should check the other Channel and Address allocations to make sure that there are no conflicts.
Resistors are measured in which of the following choices?
| ( | A | ) | | Ohms |
|
| ( | B | ) | | Farads |
|
| ( | C | ) | | Volts |
|
| ( | D | ) | | Duraps |
|
| ( | E | ) | | Inches |
The Correct Answer is: A
Explanation:
Ohms are the basic unit of measurement for Resistors.
When you are able to narrow down a grinding sound from inside the PC as coming from the hard drive, what is the most likely cause of that noise?
| ( | A | ) | | Speaker to close to hard drive |
|
| ( | B | ) | | Vibrations from the cd-rom drive |
|
| ( | C | ) | | Loose ribbon cable |
|
| ( | D | ) | | Excessive dust surrounding the drive |
|
| ( | E | ) | | HDI (Head-to-Disk Interface) |
The Correct Answer is: E
Explanation:
A grinding noise coming from the hard drive is most likely caused by an HDI situation. This occurs when a head becomes misaligned and eventually this will scratch / burn the disk making it inoperable.
IRQ2 is used with which of the following?
(this question provided by simulationexams.com)
| ( | A | ) | | COM1 |
|
| ( | B | ) | | COM2 |
|
| ( | C | ) | | LPT1 |
|
| ( | D | ) | | Used to cascade the second IRQ controller |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
Explanation:
The IRQ numbers and relevant Standard Device
Assignment are given below. It is important to memorize these values before
going to the exam, as there would be 5-10 questions on IRQs, and conflicts.
| IRQ |
Standard device Assignment |
| 0 |
System Time |
| 1 |
Keyboard |
| 2 |
Cascade to IRQ9. Can't be used |
| 3 |
COM ports 2 and 4 |
| 4 |
COM ports 1 and 3 |
| 5 |
Parallel Port LPT2. Often used for sound cards |
| 6 |
Floppy drive controller |
| 7 |
Parallel
Port, LPT1 |
| 8 |
Real Time Clock |
| 9 |
Unassigned (Also redirected from IRQ2 |
| 10 |
Available |
| 11 |
Available - Usually for SCSI adapter |
| 12 |
Mouse or touch pads |
| 13 |
Math co-processor |
| 14 |
Primary hard-disk IDE controller |
| 15 |
Secondary hard-disk controller |
This quiz was generated by user guest581333 in feb2002.
a+ certification || gmat test prep || pool game || funny joke
|
