|
Which of the following printer technologies doesn't relate to the type of printer?
| ( | A | ) | | Laser |
 |
| ( | B | ) | | Dye Sublimation |
|
| ( | C | ) | | Split-Ink |
|
| ( | D | ) | | Thermal |
|
| ( | E | ) | | Dot Matrix |
The Correct Answer is: C
The most chosen answer was [ A ] :: [ Laser ]
Explanation:
Split Ink technology is used to print security patterns across a document, usually with differing colors.
Laser, Dye Sublimation, Thermal & Dot Matrix all refer to types of printers.
Resistors are measured in which of the following choices?
| ( | A | ) | | Ohms |
|
| ( | B | ) | | Farads |
|
| ( | C | ) | | Volts |
|
| ( | D | ) | | Duraps |
|
| ( | E | ) | | Inches |
The Correct Answer is: A
Explanation:
Ohms are the basic unit of measurement for Resistors.
Which control signal on a serial cable, indicates that the data set is ready?
(this question provided by simulationexams.com)
| ( | A | ) | | DTR |
|
| ( | B | ) | | DSR |
|
| ( | C | ) | | RTS |
|
| ( | D | ) | | CTS |
|
| ( | E | ) | | None of the above |
The Correct Answer is: B
Explanation:
COM1, COM2 on a computer uses a serial cable. The pin
assignments are shown below. The computer acts as a DTE (Data Terminal Equipment)
and the Modem acts as DCE (Data Communication Equipment).
Signal--Name---------DB9 Pin
RX------Received Data--2
TX------Transmitted Data-3
DTR-----Data Terminal Ready--4
GND---- Ground--5
DSR---- Data Set Ready--6
RTS---- Request to Send--7
CTS---- Clear to send--8
Normally, a DTE device connects to a DCE device
with a straight cable. If you want to connect two DTR devices, as you would do
to hook up two computers via the serial line to exchange files, the cable itself
must have cross connections. Such a cable is called a null modem cable.
Using the Autoexec.bat file, how would you load device drivers into Upper Memory?
| ( | A | ) | | UpperMem= |
|
| ( | B | ) | | LoadHigh= |
|
| ( | C | ) | | EMM= |
|
| ( | D | ) | | HighLoad= |
|
| ( | E | ) | | Autoexec= |
The Correct Answer is: B
Explanation:
Starting a line with "LoadHigh=" followed by the location and name of the driver will load that device into Upper Memory the next time the Autoexec.bat file is run.
What is the connector type that goes with a CGA / EGA monitor?
(this question provided by simulationexams.com)
| ( | A | ) | | DB-25 |
|
| ( | B | ) | | DB-15 |
|
| ( | C | ) | | DB-9 |
|
| ( | D | ) | | DB-5 |
|
| ( | E | ) | | None of the above |
The Correct Answer is: C
Explanation:
If you are using a Monochrome / CGA/ EGA monitor, it is a digital monitor and will have a DB-9 Male connector that plugs into a digital adapter. If you are using a VGA/ SVGA monitor, it will have a male DB-15 connector that plugs into an analog adapter. You should never interchange an analog monitor to that of a digital adapter and vice versa, or severe damage may take place.
This quiz was generated by user abdulconcept in jan2002.
a+ certification || gmat test prep || pool game || funny joke
|
