|
What is the connector type that goes with a CGA / EGA monitor?
(this question provided by simulationexams.com)
| ( | A | ) | | DB-25 |
 |
| ( | B | ) | | DB-15 |
|
| ( | C | ) | | DB-9 |
|
| ( | D | ) | | DB-5 |
|
| ( | E | ) | | None of the above |
The Correct Answer is: C
The most chosen answer was [ D ] :: [ DB-5 ]
Explanation:
If you are using a Monochrome / CGA/ EGA monitor, it is a digital monitor and will have a DB-9 Male connector that plugs into a digital adapter. If you are using a VGA/ SVGA monitor, it will have a male DB-15 connector that plugs into an analog adapter. You should never interchange an analog monitor to that of a digital adapter and vice versa, or severe damage may take place.
When you are able to narrow down a grinding sound from inside the PC as coming from the hard drive, what is the most likely cause of that noise?
| ( | A | ) | | Speaker to close to hard drive |
|
| ( | B | ) | | Vibrations from the cd-rom drive |
|
| ( | C | ) | | Loose ribbon cable |
|
| ( | D | ) | | Excessive dust surrounding the drive |
|
| ( | E | ) | | HDI (Head-to-Disk Interface) |
The Correct Answer is: E
Explanation:
A grinding noise coming from the hard drive is most likely caused by an HDI situation. This occurs when a head becomes misaligned and eventually this will scratch / burn the disk making it inoperable.
Resistors are measured in which of the following choices?
| ( | A | ) | | Ohms |
|
| ( | B | ) | | Farads |
|
| ( | C | ) | | Volts |
|
| ( | D | ) | | Duraps |
|
| ( | E | ) | | Inches |
The Correct Answer is: A
Explanation:
Ohms are the basic unit of measurement for Resistors.
While installing an expansion board into a PC you are faced with a device conflict error. From the choices below, which is NOT likely to be related to the conflict.
| ( | A | ) | | DMA Channels |
|
| ( | B | ) | | RAM Addresses |
|
| ( | C | ) | | I/O Addresses |
|
| ( | D | ) | | ROM Addresses |
|
| ( | E | ) | | None are related to the conflict |
The Correct Answer is: B
Explanation:
RAM Addressing is not likely to be the cause of the conflict. You should check the other Channel and Address allocations to make sure that there are no conflicts.
How many pins a DIN-5 connector will have?
(this question provided by simulationexams.com)
| ( | A | ) | | 3 |
|
| ( | B | ) | | 4 |
|
| ( | C | ) | | 5 |
|
| ( | D | ) | | 9 |
|
| ( | E | ) | | None of the above |
The Correct Answer is: C
Explanation:
Usually, Keyboards come with two types of
connectors. They are:
1.
DIN-5
2.
Mini DIN-6
DIN-5 are used with AT style keyboards. DIN-5 has 5
pins. Mini DIN-6, also known as PS/2 connector has around port with 6 pins, one
of which being a square pin used for alignment.
This quiz was generated by user guest359045 in july2002.
a+ certification || gmat test prep || pool game || funny joke
|
