|
What is the best way to improve the airflow in a system that uses a tower case?
| ( | A | ) | | Remove the case cover |
 |
| ( | B | ) | | Install additional case fans |
|
| ( | C | ) | | Leave the CD ROM drive door open |
|
| ( | D | ) | | Lay the tower case on its side |
|
| ( | E | ) | | Use a can of compressed air |
The Correct Answer is: B
The most chosen answer was [ D ] :: [ Lay the tower case on its side ]
Explanation:
The most efficient way to improve the airflow in a tower case is to install additional case fans.
How may devices can be added to a typical SCSI adapter?
| ( | A | ) | | 8 |
|
| ( | B | ) | | 7 |
|
| ( | C | ) | | 6 |
|
| ( | D | ) | | 5 |
|
| ( | E | ) | | Infinite |
The Correct Answer is: B
Explanation:
A typical SCSI adapter can support up to 7 devices. Including the adapter would be 8 devices, but since the question asks for how many can be 'added to,' then the adapter shouldn't be included in the calculation.
Which of the following choices is the type of data transmission used by a modem?
| ( | A | ) | | Multisynchronous |
|
| ( | B | ) | | Asynchronous |
|
| ( | C | ) | | Time-delay transmission |
|
| ( | D | ) | | Synchronous |
|
| ( | E | ) | | Digital |
The Correct Answer is: D
Explanation:
Asynchronous transmission is used by modems to send data intermittently rather than at a steady stream. This allows both parties to transmit data at the same time.
What is the storage capacity of a 3 1/2" Double Sided High Density (DSHD) Floppy disk?
(this question provided by simulationexams.com)
| ( | A | ) | | 1.2 MB |
|
| ( | B | ) | | 1.44 MB |
|
| ( | C | ) | | 720 KB |
|
| ( | D | ) | | 1.4 MB |
|
| ( | E | ) | | None of the above |
The Correct Answer is: B
Explanation:
The storage capacity of various types of floppy disks that you need to know as part of A+ certification is given below:
Size------Type----Storage
5 1/4" ---DSDD----360KB
5 1/4" ---DSHD----1.2MB
3 1/2" ---DSDD----720KB
3 1/2" ---DSHD----1.44MB
3 1/2" ---DSED----2.88MB
DSDD: Double Sided Double Density
DSHD: Double Sided High Density
DSED: Double Sided Extra Density
How should the jumpers be set on an IDE CD-ROM drive that is attached to the primary IDE adapter with a hard drive?
| ( | A | ) | | All Jumpers |
|
| ( | B | ) | | No Jumpers |
|
| ( | C | ) | | Master |
|
| ( | D | ) | | Cable select |
|
| ( | E | ) | | Slave |
The Correct Answer is: E
Explanation:
The IDE Hard drive should be set as the master and the CD-ROM drive as the slave.
This quiz was generated by user guest565438 in june2002.
a+ certification || gmat test prep || pool game || funny joke
|
