|
While installing an expansion board into a PC you are faced with a device conflict error. From the choices below, which is NOT likely to be related to the conflict.
| ( | A | ) | | DMA Channels |
 |
| ( | B | ) | | RAM Addresses |
|
| ( | C | ) | | I/O Addresses |
|
| ( | D | ) | | ROM Addresses |
|
| ( | E | ) | | None are related to the conflict |
The Correct Answer is: B
The most chosen answer was [ B ] :: [ RAM Addresses ]
Explanation:
RAM Addressing is not likely to be the cause of the conflict. You should check the other Channel and Address allocations to make sure that there are no conflicts.
A Serial Port on the back of a PC would most likely be used to connect to which external device?
| ( | A | ) | | Monitor |
|
| ( | B | ) | | Scanner |
|
| ( | C | ) | | SCSI Card |
|
| ( | D | ) | | Printer |
|
| ( | E | ) | | Modem |
The Correct Answer is: E
Explanation:
External Modems are connected to a serial port. DSL and Cable Modems which aren't really 'modems' would be connected to an RJ45 port on a NIC.
At what point is it dangerous to be wearing a wrist band grounding strap?
| ( | A | ) | | While working close to an open monitor |
|
| ( | B | ) | | When removing a hard disk from a PC |
|
| ( | C | ) | | While installing additional RAM |
|
| ( | D | ) | | When using compressed air to clean the motherboard |
|
| ( | E | ) | | When replacing a bad Power Supply |
The Correct Answer is: A
Explanation:
It is very dangerous to be wearing a wrist band ground strap around an exposed monitor because the CRT (Cathode Ray Tube) will hold an incredible charge for a short time period after power has been disconnected.
Which of the following DRAM types is the fastest?
(this question provided by simulationexams.com)
| ( | A | ) | | Conventional DRAM |
|
| ( | B | ) | | FPM DRAM |
|
| ( | C | ) | | EDO DRAM |
|
| ( | D | ) | | BEDO DRAM |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
Explanation:
The following are basic types
of DRAM:
1.
Conventional DRAM
2.
Fast Page Mode DRAM
3.
Extended Data Out (EDO) DRAM
4.
Burst Extended Data Out (BEDO) DRAM
FPM DRAM typically allows
burst system timing of 5-3-3-3 at 66MHz
EDO DRAM typically allows
burst system timing of 5-2-2-2 at 66MHz
BEDO DRAM typically allows
burst system timing of 5-1-1-1 at 66MHz
There are many different connector types that are used on network cables. Which of the following is a common Network Cable Connector?
| ( | A | ) | | BNC |
|
| ( | B | ) | | RJ-45 |
|
| ( | C | ) | | AUI |
|
| ( | D | ) | | ST / SC |
|
| ( | E | ) | | All of the above are connectors |
The Correct Answer is: E
Explanation:
They are all common network cable connectors.
BNC: used with coaxial cables
RJ-45: used with 8-wire network cables, most commonly found with Ethernets.
AUI: used with coaxial cables
ST / SC: used with fiber optic cables
This quiz was generated by user sharbelwu in june2002.
a+ certification || gmat test prep || pool game || funny joke
|
