|
What tool would be used to check for line voltage sags?
| ( | A | ) | | Surge protector |
 |
| ( | B | ) | | Feedback circuit |
|
| ( | C | ) | | Terminal adapter |
|
| ( | D | ) | | Polarity tester |
|
| ( | E | ) | | High frequency monitor |
The Correct Answer is: D
The most chosen answer was [ C ] :: [ Terminal adapter ]
Explanation:
A Polarity tester is useful whenever there is a need to check for the presence of low voltage in insulated conductors, without having to touch the live cable or wire.
While installing an expansion board into a PC you are faced with a device conflict error. From the choices below, which is NOT likely to be related to the conflict.
| ( | A | ) | | DMA Channels |
|
| ( | B | ) | | RAM Addresses |
|
| ( | C | ) | | I/O Addresses |
|
| ( | D | ) | | ROM Addresses |
|
| ( | E | ) | | None are related to the conflict |
The Correct Answer is: B
Explanation:
RAM Addressing is not likely to be the cause of the conflict. You should check the other Channel and Address allocations to make sure that there are no conflicts.
Which of the following files is NOT required for DOS to boot?
(this question provided by simulationexams.com)
| ( | A | ) | | COMMAND.COM |
|
| ( | B | ) | | MSDOS.SYS |
|
| ( | C | ) | | IO.SYS |
|
| ( | D | ) | | AUTOEXEC.BAT |
|
| ( | E | ) | | None of the above are required |
The Correct Answer is: D
Explanation:
The
file load order to start DOS is :
IO.SYS
MSDOS.SYS
CONFIG.SYS
COMMAND.COM
AUTOEXEC.BAT
Note
that CONFIG.SYS, and AUTOEXEC.BAT are optional to load DOS where as IO.SYS,
MSDOS.SYS, COMMAND.COM are required.
The FDC (Floppy-disk Drive Controller) can support up to ___ floppy-disk drives.
Fill in the blank
| ( | A | ) | | 3 |
|
| ( | B | ) | | 1 |
|
| ( | C | ) | | 2 |
|
| ( | D | ) | | 5 |
|
| ( | E | ) | | unlimited |
The Correct Answer is: C
Explanation:
The FDC can support up to 2 floppy-disk drives which would be seen as A:\ and B:\.
Which protocol is used by the Internet?
| ( | A | ) | | IPX/SPX |
|
| ( | B | ) | | NetBIOS |
|
| ( | C | ) | | Data Link |
|
| ( | D | ) | | TCP/IP |
|
| ( | E | ) | | Microsoft Talk |
The Correct Answer is: D
Explanation:
The TCP/IP protocol is used to connect networks on the Internet.
This quiz was generated by user guest60187 in march2002.
a+ certification || gmat test prep || pool game || funny joke
|
