|
How would you manually setup a local printer on a Windows PC?
| ( | A | ) | | Start -> Run... -> Printer /setup |
 |
| ( | B | ) | | In Control Panel, choose Local Printer |
|
| ( | C | ) | | Under Accessories, select Printers |
|
| ( | D | ) | | In the Printer folder double-click Add Printer and choose My Computer |
|
| ( | E | ) | | In the Printer folder double-click Add Printer and choose Network Printer Server |
The Correct Answer is: D
The most chosen answer was [ D ] :: [ In the Printer folder double-click Add Printer and choose My Computer ]
Explanation:
To install a local printer onto a PC, go through the Start button, -> Settings and choose Printers. From there double click on Add Printer and select My Computer to locally install the printer.
At what point is it dangerous to be wearing a wrist band grounding strap?
| ( | A | ) | | While working close to an open monitor |
|
| ( | B | ) | | When removing a hard disk from a PC |
|
| ( | C | ) | | While installing additional RAM |
|
| ( | D | ) | | When using compressed air to clean the motherboard |
|
| ( | E | ) | | When replacing a bad Power Supply |
The Correct Answer is: A
Explanation:
It is very dangerous to be wearing a wrist band ground strap around an exposed monitor because the CRT (Cathode Ray Tube) will hold an incredible charge for a short time period after power has been disconnected.
While installing an expansion board into a PC you are faced with a device conflict error. From the choices below, which is NOT likely to be related to the conflict.
| ( | A | ) | | DMA Channels |
|
| ( | B | ) | | RAM Addresses |
|
| ( | C | ) | | I/O Addresses |
|
| ( | D | ) | | ROM Addresses |
|
| ( | E | ) | | None are related to the conflict |
The Correct Answer is: B
Explanation:
RAM Addressing is not likely to be the cause of the conflict. You should check the other Channel and Address allocations to make sure that there are no conflicts.
What is the connector type that goes with a CGA / EGA monitor?
(this question provided by simulationexams.com)
| ( | A | ) | | DB-25 |
|
| ( | B | ) | | DB-15 |
|
| ( | C | ) | | DB-9 |
|
| ( | D | ) | | DB-5 |
|
| ( | E | ) | | None of the above |
The Correct Answer is: C
Explanation:
If you are using a Monochrome / CGA/ EGA monitor, it is a digital monitor and will have a DB-9 Male connector that plugs into a digital adapter. If you are using a VGA/ SVGA monitor, it will have a male DB-15 connector that plugs into an analog adapter. You should never interchange an analog monitor to that of a digital adapter and vice versa, or severe damage may take place.
A COM Port is associated with which type of physical port?
| ( | A | ) | | Serial |
|
| ( | B | ) | | Power |
|
| ( | C | ) | | PS/2 |
|
| ( | D | ) | | SCSI |
|
| ( | E | ) | | Parallel |
The Correct Answer is: A
Explanation:
A COM Port is assigned to a Serial Port.
This quiz was generated by user peter kirowo in march2002.
a+ certification || gmat test prep || pool game || funny joke
|
