|
While booting up, a client's computer shows an error message with a code 201. What is the likely cause?
(this question provided by simulationexams.com)
| ( | A | ) | | The CMOS battery is bad |
 |
| ( | B | ) | | The CPU is bad |
|
| ( | C | ) | | The Hard disk is bad |
|
| ( | D | ) | | The Memory test has failed |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
The most chosen answer was [ A ] :: [ The CMOS battery is bad ]
Explanation:
The general errors and the corresponding failures
are shown below:
100-199 : System board failures
200-299 : Memory failures
300-399 : Key board failures
400-499 : Monochrome video problems
500-599 : Color video problems
600-699 : Floppy disk errors
1700-1799: Hard disk problems.
You are reported that the monitor at a client's place is having a problem. You are about to remove the cover of the monitor. What do you do just before opening the monitor cover? Choose all that apply.
(this question provided by simulationexams.com)
| ( | A | ) | | Wear wrist strap to prevent ESD damage to the monitor |
|
| ( | B | ) | | Make sure that the power is switched off and the power cord is plugged out |
|
| ( | C | ) | | Make sure that the ESD is grounded properly |
|
| ( | D | ) | | Connect the Monitor as well as the wrist strap to the ground. |
|
| ( | E | ) | | All of the above |
The Correct Answer is: B
Explanation:
Never wear a wrist strap when working on monitors.
Monitors contain very high voltages, sometimes fatal to human, even when the
power is turned off. If you are wearing wrist strap, the human body work as a
conduit to discharge the electric charge.
Capacitors are measured in...
| ( | A | ) | | Ohms |
|
| ( | B | ) | | Farads |
|
| ( | C | ) | | Volts |
|
| ( | D | ) | | Spindles |
|
| ( | E | ) | | Fusers |
The Correct Answer is: B
Explanation:
The Farad is the basic unit of measurement for Capacitors.
ISDN uses which of the following technologies?
| ( | A | ) | | Digital and analog |
|
| ( | B | ) | | Only analog |
|
| ( | C | ) | | Only digital |
|
| ( | D | ) | | Laser diode |
|
| ( | E | ) | | None of the above |
The Correct Answer is: C
Explanation:
ISDN uses only digital signals to transfer data packets.
The I/O address 2e8 is used for which COM port?
| ( | A | ) | | COM5 |
|
| ( | B | ) | | COM4 |
|
| ( | C | ) | | COM3 |
|
| ( | D | ) | | COM2 |
|
| ( | E | ) | | COM1 |
The Correct Answer is: B
Explanation:
COM4 uses I/O addresss 2e8.
This quiz was generated by user sparkie2253 in march2002.
a+ certification || gmat test prep || pool game || funny joke
|
