|
While booting up, a client's computer shows an error message with a code 201. What is the likely cause?
(this question provided by simulationexams.com)
| ( | A | ) | | The CMOS battery is bad |
 |
| ( | B | ) | | The CPU is bad |
|
| ( | C | ) | | The Hard disk is bad |
|
| ( | D | ) | | The Memory test has failed |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
The most chosen answer was [ A ] :: [ The CMOS battery is bad ]
Explanation:
The general errors and the corresponding failures
are shown below:
100-199 : System board failures
200-299 : Memory failures
300-399 : Key board failures
400-499 : Monochrome video problems
500-599 : Color video problems
600-699 : Floppy disk errors
1700-1799: Hard disk problems.
Which of the following still holds a charge even after the power to the system has been disconnected?
| ( | A | ) | | Capacitor |
|
| ( | B | ) | | Fuse |
|
| ( | C | ) | | SIMM chip |
|
| ( | D | ) | | CMOS |
|
| ( | E | ) | | CPU |
The Correct Answer is: A
Explanation:
The Capacitor will keep a charge for an amount of time even after all power has been disconnected. A Capacitor holds a charge in the form of an electrostatic field.
At what point is it dangerous to be wearing a wrist band grounding strap?
| ( | A | ) | | While working close to an open monitor |
|
| ( | B | ) | | When removing a hard disk from a PC |
|
| ( | C | ) | | While installing additional RAM |
|
| ( | D | ) | | When using compressed air to clean the motherboard |
|
| ( | E | ) | | When replacing a bad Power Supply |
The Correct Answer is: A
Explanation:
It is very dangerous to be wearing a wrist band ground strap around an exposed monitor because the CRT (Cathode Ray Tube) will hold an incredible charge for a short time period after power has been disconnected.
Capacitors are measured in...
| ( | A | ) | | Ohms |
|
| ( | B | ) | | Farads |
|
| ( | C | ) | | Volts |
|
| ( | D | ) | | Spindles |
|
| ( | E | ) | | Fusers |
The Correct Answer is: B
Explanation:
The Farad is the basic unit of measurement for Capacitors.
Which function key is pressed to bypass CONFIG.SYS, and AUTOEXEC.BAT during the DOS boot process?
(this question provided by simulationexams.com)
| ( | A | ) | | F6 |
|
| ( | B | ) | | F8 |
|
| ( | C | ) | | F4 |
|
| ( | D | ) | | F5 |
|
| ( | E | ) | | None of the above |
The Correct Answer is: D
Explanation:
To bypass the CONFIG.SYS, and AUTOEXEC.BAT files during boot process of DOS, you need to press F5. F8 allows you to selectively bypass commands in AUTOEXEC.BAT, and CONFIG.SYS.
This quiz was generated by user guest24397 in oct2002.
a+ certification || gmat test prep || pool game || funny joke
|
